PC 131010 » History » Revision 10

Revision 9 (Nebrensky, Henry, 17 October 2013 09:16) → Revision 10/22 (Nebrensky, Henry, 17 October 2013 09:18)

h1. Phone Meeting 
 *-Thursday 10th October- Thursday 17th October* at *15:00 BST (GMT+1)*. 

 Dial-in information is available "here": where some numbers are: 

 | *Country* | *Number* | 
 | Switzerland | 0800705351 | 
 | UK | 08004960576 |  
 | USA | 1-866-740-1260 |  

 After connecting, type in the MICO access code (ie. *5673390*) then hit #.  

 h2. Preliminary Agenda 

 * Effect of Reduced Focus Coil current on MICE Step IV and Step VI attachment:Reduced-FC-Current-Slides.odp attachment:Reduced-FC-Current-Slides.pdf (Rogers) 
 * Pion contamination in Step I (Domizia/Ole) 
 * EMR Analysis/Run progress (Ruslan) 
 * G4beamline Step 1 comparisons (Soler/Bayes/Nugent) 
 * Tracker Update (Dobbs) 
 * TOF rate analysis (Durga) 
 * Gauging the success of Step IV (Blondel/All) 
 * Multiple scattering & energy loss models (Middleton) 
 * Dipole Field-Current Discrepancy (Nebrensky) 
 ** Apologies, I'll be setting up the beamline as BLOC. 
 ** Preliminary results still in eLog entry "2413": 
 *** Note that field in centre of dipole bore (long probe) is maybe 1% less than measured against pole (short probe) so not an explanation for a >5% discrepancy 
 *** As per "VB slide": VB slide last time, should we be giving dipoles 5 minutes to settle at each setting? Or is 2 mins enough? (tolerable error?) This would need enforcing via Run Control... 
 ** I've dug out and archived on the Grid our "official" field maps for QC quads and dipoles - eLog entry "2433": 

 * AOB 

 * Next time:  
 ** Quadrupole/TOF alignment study (Overton)  
 ** Magnetic measurements (Blackmore/Leonova)  
 ** Date of next meeting: Proposed date is October 31st (NB: Clocks will have gone back in the UK at this point) 

 h2. Uploading presentations 

 Instructions on how to upload a talk if you're a presenter. 

 # Click on "edit" (and concentrate!) 
 # Click on the open box below "files" 
 # Browse and enter your file name (e.g. mytalk.pdf ) 
 # Enter the following line in the agenda box below your name (without the 'pre' tags) 
 # (e.g. attachment:mytalk.pdf ) 
 # and save